Making Folding Dining Table

Home » kitchen » Making Folding Dining Table

Folding dining table – Making the most of small spaces is what RV living is all about. One of the best ways to utilize the space is to build a folding table. It can give you counter space you need and then put aside when not in use. Measure the area where you want to place your folding table. The space should include a wall, because the table will fold against it. Transfer your measurements to the plywood, and then note the board, a square 4 inches smaller around than the original dimensions. This allows the space to get in and out from the table.

Posted on March 5, 2017 kitchen With 0 comments

RELATED TOPIC :   How To Build Kitchen Cabinet Drawers

Cut the square out of plywood. Sand the edges. Cut two-by-two so that is 4 inches shorter than the width of the folding dining table. Add your tabletop to the floor against the wall and mark on the wall where the outer edges of the table (call this mark X). Put another mark where you want the top of your tabletop to be (Y).

12 Photos Gallery of: Making Folding Dining Table

Place a third mark 2-3 / 8 inches below this mark (brand X). Hold down two and two so it is level with the “Z” and its ends are 2 inches inside the outside tracks of your folding dining table (X). Attach the wood on the wall with wood screws and a drill. This is what your table top will rest on.

RELATED TOPIC :   How to Replace a Kitchen Strainer