Repair Storm Door Latch

Home » Door » Repair Storm Door Latch

Storm door latch is a simple piece of metal that moves in and out when you press a button or turn of a lever. It allows you to access or exit a house. When a lock does not work anymore, the door does not function as intended. The most common problem with a roadblock, the lock plate, which is attached to the door frame opposite the latch. The latch fits into a hole in the lock plate to keep the door open by only blowing. When strikes are damage, the lock can not connect with strikes.

Posted on February 25, 2017 Door With 0 comments

Squats eye level with the storm door latch. Pull the door open to you, and observe where the bottom of the latch is in connection with the strike plate hole. Place a pencil mark on the edge of the strike plate hole where the bottom of the catch is.

12 Photos Gallery of: Repair Storm Door Latch

Storm Door Latch InstallSize: 1000 x 750

Storm Door Latch ImageSize: 1000 x 750

Storm Door Latch IdeaSize: 1000 x 742

Perfect Storm Door LatchSize: 1000 x 750

Nice Storm Door LatchSize: 1280 x 720

New Storm Door LatchSize: 1500 x 1500

Great Storm Door LatchSize: 1280 x 720

Good Storm Door LatchSize: 1600 x 1200

Cute Storm Door LatchSize: 1200 x 900

Best Storm Door LatchSize: 1600 x 1200

Awesome Storm Door LatchSize: 1280 x 720

Amazing Storm Door LatchSize: 1280 x 720

RELATED TOPIC :   Step By Step Doorbell Installation

Repair storm door latch, hold strikes back in its original position. And check the bottom of the strike is higher than the pencil line. The lock will not fit into the receiver hole at the bottom of the strike is too high. The same applies if the strike is too low. Adjust the height of the strike plate up or down based on the location of the pencil line. Place a screw in the end of the drill bit; hold strikes in his new position, and insert the screw through the top hole of the anchor strikes, before inserting bottom screw.

RELATED TOPIC :   Quick Installations Exterior Door Knobs