How To Replace A Finger Pulls With Different Size Of The Old
How To Replace A Finger Pulls With Different Size Of The Old – In this case the new measure is not in accordance with the size of the old one. First, get the meter and measures the distance between the two screw holes. It is easier if you have a template, this will assure you that the pull of the finger is positioned in the right way. But if there is no template, you have to measure the entire length of the closet door. Then divide it into 2. Mark the center of the closet doors, and then drag your finger position right in the middle. Once you have positioned drag a finger, mark the screw holes by placing a pencil in the hole and put a sign on it.
To install the finger pulls on the door, make a hole drilled in the area marked. Select a few that has a smaller diameter than the screw. When drilling, make sure that you do not drill too far. Which may cause a hole in the other side of the closet door. Drilling stop when it reaches ¾ of the size of the screw. After creating a hole, the hole position of pull my finger on it and attach the screw. Tighten once you are sure the position of the finger pull.
12 Photos Gallery of: How To Replace A Finger Pulls With Different Size Of The Old
If there are some cabinet doors that you need to put the finger pulls, you just need to repeat the process on all of them. Remember, it is important that your measurements must conform. Measurement is an important part in this process. If you do not measure correctly. You may damage the cabinet doors due to the number of holes you might make.